Tuesday, 28 September 2010

Flaperon Actutation Brackets - Done


Took advantage of a called off IMC lesson today to work on the flaperon actuation brackets...... Or should I say make them from aluminum stock!

In total about four hours work to make both brackets and I’m as confident as I can be that I’ve done a decent job, all the measurements where checked and double check so they just need priming then I can fit them. Doing these was one of the jobs I feared as I heard lots of other builders having a few issues so I read up, read up some more and then proceeded with caution.

One tricky thing was drilling the hole in the bracket as it called for a 03/16 drill that I didn’t have or at least that’s what I thought, a quick trip to the local diy shop revealed a 03/16 drill is a No.8 or 5mm in new money which I already had so a couple of quid saved on this step.

No comments:

Post a comment